IBM pSeries 670 Service Manual page 394

Hide thumbs Also See for pSeries 670:

Table of Contents

Error Code Description

101A FE76 BPR 3A communications fault

101A FFx6 Cabling error on the BPC or a BPD that is not

101A x115 Power cable fault

101A x125 Power cable fault

101A x135 Power cable fault

101A x215 Power cable fault

101A x225 Power cable fault

101A x235 Power cable fault

101A x315 Power cable fault

101A x325 Power cable fault

101A x335 Power cable fault

Eserver pSeries 670 Service Guide

Possible Failing FRU

Go to "MAP 1523: There Is a Bulk Power

Regulator (BPR) Communications Fault" on

There is a cabling problem on a BPC or BPD

that cannot be isolated.

The x is decoded as follows:

If x=1, the problem is on the BPC, location:

If x=2, the problem is on BPD-1, location:

If x=3, the problem is on BPD-2, location:

If x=4, the problem is on BPD-3, location:

Check the UPIC cabling on the BPC or BPD

specified by decoding the x as shown above.

Correct any cabling problems that are found.

2. If no problems are found on the A side of the

BPE, check the UPIC cabling on the BPC or

BPD in the same position on the B side of

the BPE for cabling errors. Correct and

problems that are found.

3. If both sides of the BPE are cabled correctly,

call service support.