IBM pSeries 670 Service Manual page 875

Replacing a PCI Adapter Cassette:
Attention: Perform this procedure only when you are instructed to from "Removing a Non-Hot-Pluggable
PCI Adapter" on page 857 or "Hot-Pluggable PCI Adapter" on page 858. Before you replace the PCI
adapter cassette, check the following:
v Before installing a PCI adapter cassette in the system, an adapter or blank filler must be installed in
each PCI adapter cassette and the top cover for the system must be installed.
v Check the adapter in the cassette that you are about to install, and make sure that the adapter is held
firmly on all four corners by the retaining arms and ratchet clips.
v Review the procedures beginning with "PCI Adapter or Blank Filler Removal from a
Snap-Assembly-Type Cassette" on page 872 to make sure that the adapter is correctly installed in the
cassette.
To replace a PCI adapter cassette, do the following:
1. Depress the handle release lever located in the center of the PCI adapter cassette handle. Move the
handle down completely to the fully down position. See the following illustration.
2. Push the top of the locking bar in until it clicks into the locked position.
1 Cassette Dovetail Rails
2 Handle-Release Lever Latch
3 Handle Release Lever
Chapter 9. Removal and Replacement Procedures
855