IBM pSeries 670 Service Manual page 879

11. Answer YES to Keep Definition. Press Enter.
12. The ARE YOU SURE screen displays. Press Enter to verify the information. Successful
unconfiguration is indicated by the OK message displayed next to the Command field at the top of the
screen.
13. Press F3 to return to the PCI Hot-Plug Manager menu.
14. Select Replace/Remove a PCI Hot-Plug Adapter and press Enter. The Replace/Remove a PCI
Hot-Plug Adapter menu displays.
15. Move the cursor to select the adapter that you are removing and press Enter. If you are not replacing
the adapter, the description entry displays as unknown.
16. If you are replacing the adapter, press the Tab key until the entry field displays the replace operation,
and then press Enter. If you are not replacing the adapter, press the Tab key until the entry field
displays the remove operation, and then press Enter. Follow the instructions that display on the
screen until you are instructed to remove the adapter.
17. When you are instructed to remove the adapter from the adapter slot, disconnect any cables that are
connected to the adapter being removed, and then refer to "Removing a PCI Adapter Cassette" on
page 852.
18. Install the replacement adapter into the PCI adapter cassette. See "PCI Adapter or Blank Filler
Removal from a Snap-Assembly-Type Cassette" on page 872.
19. With the replaced adapter installed into the PCI adapter cassette, refer to "Replacing a PCI Adapter
Cassette" on page 855.
20. If you installed an adapter into the adapter cassette, connect the appropriate cables and devices to
the adapter connectors.
21. Continue to follow the screen instructions until you receive a message that the replacement is
successful. Successful replacement is indicated by the OK message displayed next to the Command
field at the top of the screen.
22. If you did not install an adapter into the adapter cassette, go to step 23. If you did install an adapter
into the adapter cassette, do the following:
a. Press the F3 key to return to the PCI Hot-Plug Manager menu.
b. Select Install/Configure Devices Added After IPL and press Enter. Then follow the instructions
on the screen. Successful replacement is indicated by the OK message displayed next to the
Command field at the top of the screen.
23. If you do not have other adapters to replace, continue with the next step.
OR
If you have other adapters to replace, press the F3 key to return to the PCI Hot-Plug Manager menu
and then return to step 14.
24. Press F10 to exit the Hot-Plug Manager.
If you have added, removed, or replaced any adapters, run the diag -a command. If the system
responds with a menu or prompt, follow the instructions to complete the device configuration.
Chapter 9. Removal and Replacement Procedures
859