IBM pSeries 670 Service Manual page 889

6. When the lower corner of the card is fully seated into the bezel, rotate the top of the bezel over the
tailstock of the card.
7. Position the bezel fully onto the assembly by snapping the three small holes on bezel arm over the
three small embossments on the linkage assembly, as shown in the following illustration.
1 Adapter Card
2 Adapter Card (Lower Corner)
3 Front Bottom Clip
4 Adapter Cassette Bezel
1 Alignment Studs
2 Adapter Card
3 ESD Surface
Chapter 9. Removal and Replacement Procedures
869