IBM pSeries 670 Service Manual page 628

Error Code Description
406F 0EB8 Attention line 7 stuck fault
406F 0EB9 Attention line 8 stuck fault
406F 0EBA Attention line 9 stuck fault
406F 0EBB Attention line 10 stuck fault
406F 0EBC Attention line 11 stuck fault
406F 0EBF Memory error
406F 0EE1 Error code generation/logging detected fault in
service processor code (invalid MRU to
mapping)
406F 0EE2 Error code generation/logging detected fault in
service processor firmware fault
406F 0EE5 Error code generation/logging detected
firmware error; no callout available
406F 25E6 SMA 4-port switch adapter fault
406F 273F SMA 2-port switch adapter fault
608 Eserver pSeries 670 Service Guide
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
1. Reboot the system in slow mode to the
SMS menus. See "Performing Slow Boot"
on page 345.
2. Examine the service processor error log.
v If a CEC subsystem error (a 4xxx yyyy
error) occurred during the slow boot that
calls out the memory, processors, L3
cache modules, or the primary I/O book,
replace the part indicated by the location
code.
v If a CEC subsystem error (a 4xxx yyyy
error) did not occur during the slow boot,
look for a 4xxx yyyy error immediately
preceding the 406x 0EBF error. Replace
the part indicated by the location code
associated with that error.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
Replace the I/O book (switch adapter) specified
by the location code.
Replace the I/O book (switch adapter) specified
by the location code.