IBM pSeries 670 Service Manual page 444

Error Code Description
20EE 0011 Unable to execute the root-lpar-vpd vpd
method
20EE 0012 Unable to execute the mem-dimm-vpd method 1. Verify that the system is in LPAR mode,
20EE 0013 Unable to allocate memory for root-lpar-vpd
vpd
20EE 0014 Unable to allocate memory for root-lpar-vpd
location codes
20EE 0020 The boot-device environment variable
exceeds the allowed character limit
20EE 0021 The boot-device environment variable
contained more than five entries
424 Eserver pSeries 670 Service Guide
Action/
Possible Failing FRU
1. Verify that the system is in LPAR mode,
and reboot the system.
2. Reflash the system with the latest level of
system firmware.
3. Call service support.
and reboot the system.
2. Reflash the system with the latest level of
system firmware.
3. Call service support.
1. Verify that the system is in LPAR mode,
and reboot the system.
2. Reflash the system with the latest level of
system firmware.
3. Call service support.
Verify that the system is in LPAR mode, and
try again. Otherwise, the system firmware
may be damaged.
If this error occurs during the installation of
AIX via a process called NIM push, the
set_bootlist attribute may not have been set
correctly on the NIM master. See the AIX 5.2
Installation Guide and Reference, order
number SC23-4389, for more information.
If this error occurs at any other time, complete
the following steps:
1. Check for platform firmware updates.
Apply if available.
2. Call service support.
If this error occurs during the installation of
AIX via a process called NIM push, the
set_bootlist attribute may not have been set
correctly on the NIM master. See the AIX 5.2
Installation Guide and Reference, order
number SC23-4389, for more information.
If this error occurs at any other time, complete
the following steps:
1. Check for platform firmware updates.
Apply if available.
2. Call service support.