IBM pSeries 670 Service Manual page 887

4. Attach the appropriate short card (if the card does not extend beyond the mark at the top of the
linkage subassembly) or long card arm to the support arm of the linkage subassembly as follows:
1 Mark at the Top of Linkage
Subassembly
2 Top Rear Clip (Shown on the long
and short card arms)
3 Long Card Arm
4 Short Card Arm
Note: Ensure the card arm is fully on the track and clears the end of the support arm of the linkage
subassembly. A flat head screwdriver might be needed to push the card arm in the remaining
distance.
a. Bend the support arm downward, to allow the card arm to slide onto the end of the support arm.
b. Slide the card arm until the top-rear and lower clips align with the edge of the card.
c. Press the lower clip under the bottom edge of the card. The bottom of the clip should be even
with the bottom of the card.
5 Short Adapter
6 Top Front Clip
7 Long Adapter
Chapter 9. Removal and Replacement Procedures
867