Call-In/Call-Out Setup Menu - IBM pSeries 670 Service Manual

Call-In/Call-Out Setup Menu

Note: The information in this section regarding the configuring of serial ports, and modems attached to
those serial ports, applies only to the serial ports (S1 and S2) on the primary I/O book (location
U1.18-P1-H2). These serial ports are normally used for call-in and call-out.
Call-out is disabled in partitioned systems. The call-out function is normally handled by the Service
Focal Point application running on the HMC.
None of these menus are applicable to the serial ports, or modems attached to those serial ports,
on the hardware management console (HMC).
CALL-IN/CALL-OUT SETUP MENU
1. Modem Configuration Menu
2. Serial Port Selection Menu
3. Serial Port Speed Setup Menu
4. Telephone Number Setup Menu
5. Call-Out Policy Setup Menu
6. Customer Account Setup Menu
7. Call-Out Test
NOT supported in LPAR mode.
98. Return to Previous Menu
99. Exit from Menus
0>
v Modem Configuration Menu, see "Modem Configuration Menu" on page 737.
v Serial Port Selection Menu, see "Serial Port Selection Menu" on page 738.
v Serial Port Speed Setup Menu, see "Serial Port Speed Setup Menu" on page 739.
v Telephone Number Setup Menu, see "Telephone Number Setup Menu" on page 739.
v Call-Out Policy Setup Menu, see "Call-Out Policy Setup Menu" on page 741.
v Customer Account Setup Menu, see "Customer Account Setup Menu" on page 742.
v Call-Out Test tests the configuration after the modem is installed and configured correctly.
Note: If the system is running in partition mode, the call-out option is disabled.
736 Eserver pSeries 670 Service Guide