Symptom
The system stops and a 3-digit number is
displayed in the operator panel display.
The system stops and a 4-digit number
beginning with 0 or 2 is displayed in the
operator panel display.
The system will not boot.
All other symptoms.
Quick Entry MAP
Quick Entry MAP Table of Contents
Problem Description
Service Actions
A Repeating Data Pattern Appears on the Operator Panel Display
OK Does Not Appear in the Primary I/O Drawer Operator Panel Display
Before Pressing the Power On Button
8-Digit Error Codes
System Stops With an 8-Digit Number Displayed
System Stops With a 4-Digit Number That Does Not Begin With 0 or 2
Displayed
System Stops With a 3-Digit Number Displayed
System Stops or Hangs With Alternating Numbers Displayed in the Operator
Display Panel.
There Is a Display Problem (Distortion, Blurring, Etc.)
Power and Cooling Problems
Flashing 888 in Operator Panel Display
Other Symptoms or Problems
You Cannot Find the Symptom in this Table
Attention:
corrected, go to "MAP 1540: Minimum Configuration" on page 57 unless otherwise
indicated in the tables.
If you replace FRUs or perform an action and the problem is corrected, go to "MAP
410: Repair Checkout" in RS/6000 and Eserver pSeries Diagnostic Information for
Multiple Bus Systems .
42
Service Guide
If you replace FRUs or perform an action and the problem is still not
Starting Point
Record SRN 101-xxx, where xxx is the 3-digit
number displayed in the operator panel display,
then go to the Fast Path MAP in the RS/6000
and Eserver pSeries Diagnostic Information
for Multiple Bus Systems .
Go to the Fast Path MAP in the RS/6000 and
Eserver pSeries Diagnostic Information for
Multiple Bus Systems .
Go to "Quick Entry MAP".
Go to "Quick Entry MAP".
Page No.
43
43
43
43
43
44
44
44
44
45
45
45
48