IBM pSeries 670 Service Manual page 502

Error Code Description
4066 0EB8 Attention line 7 stuck fault
4066 0EB9 Attention line 8 stuck fault
4066 0EBA Attention line 9 stuck fault
4066 0EBB Attention line 10 stuck fault
4066 0EBC Attention line 11 stuck fault
4066 0EBF Memory error
4066 0EE1 Scan interface basic assurance tests detected
fault in service processor code (invalid MRU to
mapping)
4066 0EE2 Scan interface basic assurance tests detected
fault in service processor firmware fault
4066 0EE5 Scan interface basic assurance tests detected
firmware error; no callout available
4066 25E6 SMA 4-port switch adapter fault
4066 273F SMA 2-port switch adapter fault
4067 0001 Bus tests detected clock card assembly failure
4067 0002 Bus tests detected backplane assembly failure
4067 0003 Bus tests detected fault in MCM module 0
4067 0004 Bus tests detected fault in MCM module 2
4067 0005 Bus tests detected fault in MCM module 1
482 Eserver pSeries 670 Service Guide
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
1. Reboot the system in slow mode to the
SMS menus. See "Performing Slow Boot"
on page 345.
2. Examine the service processor error log.
v If a CEC subsystem error (a 4xxx yyyy
error) occurred during the slow boot that
calls out the memory, processors, L3
cache modules, or the primary I/O book,
replace the part indicated by the location
code.
v If a CEC subsystem error (a 4xxx yyyy
error) did not occur during the slow boot,
look for a 4xxx yyyy error immediately
preceding the 406x 0EBF error. Replace
the part indicated by the location code
associated with that error.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
Replace the I/O book (switch adapter) specified
by the location code.
Replace the I/O book (switch adapter) specified
by the location code.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
MCM module 0 and VPD card
Location: U1.18-P1-C1 and U1.18-P1-H2.3
MCM module 2 and VPD card
Location: U1.18-P1-C4 and U1.18-P1-H2.4
MCM module 1 and VPD card
Location: U1.18-P1-C3 and U1.18-P1-H2.5