IBM pSeries 670 Service Manual page 737

v OS Surveillance Setup Menu
Note: This option is disabled in partitioned systems.
This menu can be used to set up operating system (OS) surveillance.
OS Surveillance Setup Menu
1. Surveillance:
Currently Enabled
2. Surveillance Time Interval:
2 minutes
3. Surveillance Delay:
2 minutes
98. Return to Previous Menu
0>
– Surveillance
Can be set to Enabled or Disabled.
– Surveillance Time Interval
Can be set to any number from 2 through 255.
– Surveillance Delay
Can be set to any number from 0 through 255.
Refer to "Service Processor System Monitoring - Surveillance" on page 752 for more information about
surveillance.
v Reset Service Processor
If this option is selected, entering Y causes the service processor to reboot.
v Reprogram Flash EPROM Menu
This option updates the system EPROMs. After entering Y to indicate that you want to continue, you are
prompted to enter the update diskettes. Follow the instructions on the screen. When the update is
complete, the service processor reboots.
All system EPROMs that can be reprogrammed are updated at the same time and are as follows:
– System power control network programming
– Service processor programming
– System firmware programming
– Run-Time Abstraction Services
Chapter 7. Using the Service Processor
717