IBM pSeries 670 Service Manual page 355

Table 2. Firmware Checkpoints (continued)
Checkpoint
E584
E585
E586
E587
E588
E589
E58A
E58B
E58C
Description
Checking function of current EADS
Valid function of current EADS detected
Set up EADS function
Set up EADS BIST
Set up EADS function registers
Set up EADS function
Set up EADS function registers
Set up EADS function registers
Set up EADS function registers
Action/
Possible Failing FRU
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
Chapter 4. Checkpoints
335