Fan Main - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.10.6 FAN MAIN

Disassembly procedures for this part are different between EPL-
C H E C K
N3000 and AcuLaser M4000N. For AcuLaser M4000N, see
P O I N T
FAN MAIN (AcuLaser M4000N)
Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Disconnect the connector (P/J244) of the FAN MAIN from the HARNESS ASSY
TRAY 1.
4. Remove the two screws (silver, tapping, 30mm) securing the FAN MAIN to the
frame, and remove the FAN MAIN.
Installation
1. Install the FAN MAIN to the frame with the two screws (silver, tapping, 30mm).
Install the FAN MAIN with its label surface located on the
C A U T I O N
outside.
When installing the FAN MAIN, be careful so that the harness
is not caught between the FAN MAIN and frame.
2. Connect the connector (P/J244) of the FAN MAIN to the HARNESS ASSY
TRAY 1.
3. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
4. Install the COVER REAR 500. (p.270)
Disassembly and Assembly
4.14.8
(p.392).
Electrical
LABEL
3)
4)
FAN MAIN
Figure 4- 97. FAN MAIN Removal
Revision C
JG3022EA
293
Confidential