Epson EPL-N3000 Service Manual page 250

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the LEVER GUIDE to the GUIDE CRU LEFT.
2. Install the GUIDE SL to the GUIDE CRU LEFT.
3. Install the SPACER SS to the GUIDE CRU LEFT.
4. Install the SPRING SL to the GUIDE CRU LEFT.
5. Install the INTERLOCK S/W 24V, INTERLOCK S/W 5V. (p.247)
6. Install the COVER GUIDE CRU and HARNESS ASSY FUSER.
7. Install the GUIDE CRU LEFT. (p.245)
When installing the GUIDE CRU LEFT, make sure that the
C A U T I O N
LEVER LINK is mounted on the GUIDE CRU LEFT.
8. Install the SHIELD PLATE LVPS. (p.285)
9. Install the MOTOR COVER. (p.277)
10. Install the GUIDE TRAY LEFT. (p.236)
11. Install the SHIELD PLATE ROS. (p.243)
12. Install the ROS ASSY. (p.239)
Never give impact to the ROS ASSY with a screwdriver or the like.
C A U T I O N
13. Install the DUCT FRONT, FAN SUB. (p.241)
14. Install the COVER FRONT. (p.172)
15. Install the COVER TOP, CONTROL PANEL. (p.170)
16. Install the 500 EXIT ASSY. (p.262)
17. Install the COVER EXIT 500. (p.261)
18. Install the COVER RIGHT. (p.168)
19. Install the COVER LEFT. (p.169)
Disassembly and Assembly
20. Install the FUSER ASSY. (p.253)
21. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
22. Install the COVER REAR 500. (p.270)
(p.251)
23. Install the BTR ASSY. (p.254)
Xero
Revision C
250
Confidential