Epson EPL-N3000 Service Manual page 264

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Remove the LINK GATE OCT that is assembled to the removed CHUTE UP
EXIT.
2. Secure the CHUTE UP EXIT to the CHUTE LOW EXIT with the two screws
(gold, tapping, 8mm).
3. Put the LINK GATE OCT in the place shown in Figure 1 in the two arm sections
of the CHUTE LOW EXIT, and turn it in the direction of the arrow.
4. Push the LINK GATE OCT in the direction of the arrow shown in Figure 2 as far
as it will go to have it locked by the CHUTE LOW EXIT.
After installation, make sure that the LINK GATE OCT is
C H E C K
located in the far side of the GATE. (Note 1)
P O I N T
After installation, make sure that the front end of the LINK
GATE OCT is located under the hook of the CHUTE LOW
EXIT. (Note 2)
After installation, make sure that the GATE moves when the
LINK GATE OCT is pushed in the direction of the arrow.
(Note 2)
5. Install the 500 EXIT ASSY. (p.262)
6. Install the COVER EXIT 500. (p.261)
7. Install the COVER RIGHT. (p.168)
8. Install the COVER LEFT. (p.169)
9. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
10. Install the COVER REAR 500. (p.270)
Disassembly and Assembly
Note1)
Figure 4- 75. CHUTE UP EXIT, CHUTE LOW EXIT Installation
500 Paper Exit
LINK Note2)
HOOK
GATE OCT
GATE
Revision C
JG3079AA
264
Confidential