Epson EPL-N3000 Service Manual page 358

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the SWITCH DUPLEX to the BRACKET MOTOR, and secure it with the
hooks.
2. Connect the HARNESS ASSY DUP COVER to the connector (P/J52) of the
SWITCH DUPLEX.
3. Install the BRACKET MOTOR to the COVER HSG DUP with the three screws
(gold, tapping, 8mm).
When installing the BRACKET MOTOR, be careful not to mislay
C H E C K
the gears.
P O I N T
4. Install the SPRING LATCH between the BRACKET MOTOR and LEVER
LATCH LEFT.
5. Install the HARNESS ASSY DUP EARTH with the one screw (silver, 6mm).
6. Install the PWBA DUPLEX. (p.347)
When installing the PWBA DUPLEX, pay attention to its
C A U T I O N
installation orientation.
7. Install the COVER TOP. (p.346)
When installing the COVER TOP, match its positioning holes with
C H E C K
the bosses of the COVER HSG DUP.
P O I N T
8. Install the COVER LEFT. (p.353)
When installing the COVER LEFT, match its positioning holes
C H E C K
with the bosses of the COVER HSG DUP.
P O I N T
Disassembly and Assembly Option Duplex
Revision C
358
Confidential