Epson EPL-N3000 Service Manual page 229

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the ROLL ASSY GEAR NUDGER to the SHAFT NUDGER, and secure it
with the hook.
When installing the GEAR NUDGER, take care not to hold any
C A U T I O N
rubber portion.
Engage the hooks of the GEAR NUDGER with the grooves in
the SHAFT NUDGER properly.
2. Install the ROLL ASSY NUDGER to the SHAFT NUDGER, and secure it with
the hook.
When installing the ROLL ASSY NUDGER, take care not to
C A U T I O N
hold its rubber portion.
Engage the hooks of the ROLL ASSY NUDGER with the
grooves in the SHAFT NUDGER properly.
3. Install the HOLDER LEFT and ACTUATOR NO PAPER to the SUPPORT
NUDGER.
Securely fit the shafts on both ends of the ACTUATOR NO
C A U T I O N
PAPER into the HOLDER LEFT and SUPPORT NUDGER.
Hitch the hook of the ACTUATOR NO PAPER on the
HOLDER LEFT.
After installation, operate the ACTUATOR NO PAPER with your
C H E C K
finger and make sure that it moves properly.
P O I N T
4. Move the HOLDER LEFT in the direction opposite to the arrow, and secure it to
the 550 FEEDER ASSY with the three hooks.
5. Return the printer body to the normal position.
6. Install the FUSER ASSY. (p.253)
7. Install the COVER REAR 500. (p.270)
Disassembly and Assembly 550 Paper Feeder
Revision C
229
Confidential