Actuator Full Stack - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.8.8 ACTUATOR FULL STACK

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Remove the COVER LEFT. (p.169)
4. Remove the COVER RIGHT. (p.168)
5. Remove the COVER EXIT 500. (p.261)
6. Remove the CHUTE UP EXIT, CHUTE LOW EXIT. (p.263)
7. Move the ACTUATOR FULL STACK in the direction of the arrow, and remove it
from the CHUTE UP EXIT.
Installation
1. Move the ACTUATOR FULL STACK in the direction opposite to the arrow, and
install it to the CHUTE UP EXIT.
2. Install the CHUTE UP EXIT, CHUTE LOW EXIT. (p.263)
3. Install the COVER EXIT 500. (p.261)
4. Install the COVER RIGHT. (p.168)
5. Install the COVER LEFT. (p.169)
6. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
7. Install the COVER REAR 500. (p.270)
Disassembly and Assembly
7)
CHUTE UP EXIT
Figure 4- 80. ACTUATOR FULL STACK Removal
500 Paper Exit
Revision C
JG3136AA
269
Confidential