Exit Assy - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.8.2 500 EXIT ASSY

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Remove the COVER LEFT. (p.169)
4. Remove the COVER RIGHT. (p.168)
5. Remove the COVER EXIT 500. (p.261)
6. Remove the SHIELD ASSY ESS. (p.294)
7. Disconnect the connector (P/J29) of the HARNESS ASSY EXIT SNR from the
HVPS/MCU.
8. Disconnect the connector (P/J103) of the MOTOR ASSY EXIT from the PWBA
EXIT MOTOR.
9. Remove the five screws (silver, with flange, 8mm, 4 pcs., silver, 6mm, 1 pc.)
securing the 500 EXIT ASSY to the printer body.
10. Remove the 500 EXIT ASSY. (p.262)
Installation
1. Pass the harnesses of the MOTOR ASSY EXIT and SENSOR through the hole of
the frame.
2. Install the 500 EXIT ASSY with the five screws (silver, with flange, 8mm, 4 pcs.,
silver, 6mm, 1 pc.).
3. Connect the connector (P/J103) of the MOTOR ASSY EXIT to the PWBA EXIT
MOTOR.
4. Connect the connector (P/J29) of the HARNESS ASSY EXIT SNR to the HVPS/
MCU.
5. Install the SHIELD ASSY ESS. (p.294)
6. Install the COVER EXIT 500. (p.261)
7. Install the COVER RIGHT. (p.168)
8. Install the COVER LEFT. (p.169)
9. Install the COVER REAR. (p.167)
Disassembly and Assembly
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
10. Install the COVER REAR 500. (
SHIELD ASSY ESS
Figure 4- 73. 500 EXIT ASSY Removal
500 Paper Exit
)
p.270
500 EXIT ASSY
8)
6)
9)
PWBA EXIT MOTOR
7)
Revision C
JG3017EB
262
Confidential