Epson EPL-N3000 Service Manual page 345

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the HSG LOWER DUP to the COVER HSG DUP with the two SCREWs
HINGE.
2. Install the SPRING DAMPER to the COVER HSG DUP with the SCREW
TAPPING.
3. Secure the HARNESS ASSY DUP with the harness clamp as shown in the figure.
4. Secure the HARNESS ASSY DUP EARTH with the one screw (silver, 6mm).
5. Connect the connector of the HARNESS ASSY DUP to the PWBA DUPLEX.
6. Install the COVER RIGHT. (p.354)
When installing the COVER RIGHT, match its positioning holes
C H E C K
with the bosses of the COVER HSG DUP.
P O I N T
7. Install the COVER LEFT. (p.353)
When installing the COVER LEFT, match its positioning holes
C H E C K
with the bosses of the COVER HSG DUP.
P O I N T
Disassembly and Assembly Option Duplex
Revision C
345
Confidential