Fan Main (Aculaser M4000N) - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.14.8 FAN MAIN (AcuLaser M4000N)

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR (AcuLaser M4000N). (p.379)
3. Remove the two screws (silver, tapping, 8mm) securing the FAN MAIN to the
COVER REAR, and remove the FAN MAIN.
Installation
1. Install the FAN MAIN to the COVER REAR with the two screws (silver, tapping,
8mm).
Install the FAN MAIN with its label surface located on the
C A U T I O N
outside.
When installing the FAN MAIN, be careful so that the harness
is not caught between the FAN MAIN and COVER REAR.
2. Install the COVER REAR (AcuLaser M4000N). (p.379)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
3. Install the COVER REAR 500. (p.270)
Disassembly and Assembly AcuLaser M4000N Unique Disassembly Procedures
LABEL
Figure 4- 181. FAN MAIN Removal
Revision C
J23165AA
392
Confidential