Epson EPL-N3000 Service Manual page 246

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the GUIDE CRU LEFT to the frame.
When installing the GUIDE CRU LEFT, make sure that the
C A U T I O N
LEVER LINK is mounted on the GUIDE CRU LEFT.
2. Secure the GUIDE CRU LEFT with the three screws (gold, 6mm).
After securing the GUIDE CRU LEFT with the three screws, pull
C H E C K
up the LEVER LINK. At this time, confirm with your finger that
P O I N T
the LINK GEAR 3 retracts.
3. Connect the connector (P/J46 and P/J47) of the HARNESS ASSY FUSER to the
LVPS.
4. Connect the connector (P/J45) of the INTERLOCK S/W 24V to the LVPS.
5. Connect the connector (P/J141) of the INTERLOCK S/W 5V to the HARNESS
ASSY LVPS.
6. Secure the HARNESS ASSY FUSER, coming out of the GUIDE CRU LEFT, to
the frame with the clamp.
7. Connect the connector (P/J4647) of the HARNESS ASSY FUSER to the frame.
8. Install the SHIELD PLATE LVPS. (p.285)
9. While lifting the 150 FEEDER ASSY, install the MOTOR COVER.
10. Install the SHIELD PLATE ROS. (p.243)
11. Install the ROS ASSY. (p.239)
Never give impact to the ROS ASSY with a screwdriver or the like.
C A U T I O N
12. Install the DUCT FRONT, FAN SUB. (p.241)
13. Install the GUIDE TRAY LEFT. (p.236)
Disassembly and Assembly
14. Install the BTR ASSY. (p.254)
15. Install the FUSER ASSY. (p.253)
16. Install the COVER FRONT. (p.172)
17. Install the COVER TOP, CONTROL PANEL. (p.170)
18. Install the 500 EXIT ASSY. (p.262)
19. Install the COVER EXIT 500. (p.261)
20. Install the COVER RIGHT. (p.168)
21. Install the COVER LEFT. (p.169)
22. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
23. Install the COVER REAR 500. (p.270)
(p.277)
Xero
Revision C
246
Confidential