Epson EPL-N3000 Service Manual page 212

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. While lifting the 150 FEEDER ASSY in the direction of the arrow (A), insert it
into the printer body, and engage the bosses on the left and right sides of the 150
FEEDER ASSY with the printer body.
2. Secure the 150 FEEDER ASSY to the printer body with the five screws (sliver,
with collars, with spring washers, 8mm).
One of the screws for securing the 150 FEEDER ASSY also tightens
C H E C K
the EARTH PLATE BASE.
P O I N T
3. Connect the connector (P/J245) of the HARNESS ASSY TRAY 1 to the
HARNESS ASSY CHUTE.
4. With the BTR ASSY installed, install the CHUTE TRANSFER.
In the hole on the left side of the CHUTE TRANSFER, a screw need
C H E C K
not be tightened.
P O I N T
5. Install the FAN MAIN. (p.293)
6. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C H E C K
use them at their correct positions respectively.
P O I N T
7. Install the FUSER ASSY. (p.253)
8. Install the COVER REAR 500. (p.270)
Disassembly and Assembly
(p.255)
150 Paper Feeder
Revision C
212
Confidential