Roll Assy Gear Nudger - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.6.4 ROLL ASSY GEAR NUDGER

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the FUSER ASSY. (p.253)
3. Lay the printer body on its left side.
Take care not to damage the covers. In addition, take care not to
C A U T I O N
apply any impact from above.
4. Open the COVER OPEN.
5. While pushing up the boss of the HOLDER LEFT on the rear side of the 550
FEEDER ASSY, shift the HOLDER LEFT in the direction of the arrow, and
release the three hooks.
6. Remove the HOLDER LEFT from the SUPPORT NUDGER. At the same time,
the ACTUATOR NO PAPER comes off.
7. Release the hook of the ROLL ASSY NUDGER, and pull the ROLL ASSY
NUDGER out of the SHAFT NUDGER.
In removal, take care not to hold any rubber portion of the ROLL
C A U T I O N
ASSY NUDGER.
8. Release the hook of the GEAR NUDGER, and pull the ROLL ASSY GEAR
NUDGER out of the SHAFT NUDGER.
In removal, take care not to hold any rubber portion of the GEAR
C A U T I O N
NUDGER.
Disassembly and Assembly
SUPPORT
NUDGER
ACTUATOR
NO PAPER
LIFT UP
(BOSS)
HOLDER
LEFT
LIFT UP
(BOSS)
HOLDER
LEFT
Figure 4- 52. ROLL ASSY GEAR NUDGER Removal
550 Paper Feeder
ROLL ASSY NUDGER
ROLL ASSY
GEAR NUDGER
SUPPORT
NUDGER
HOOK
Revision C
ACTUATOR
NO PAPER
HOOK
HOLDER
LEFT
JG3051AB
228
Confidential