Drive Assy Opt Fdr - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.11.5 DRIVE ASSY OPT FDR

Removal
1. Remove the 550 FEEDER OPTION. (p.311)
2. Remove the COVER LEFT PLATE. (p.305)
3. Disconnect the connector (P/J820) of the MOTOR FEEDER, which is installed on
the DRIVE ASSY OTP FDR, from the HARNESS ASSY FDR MOT.
4. Remove the three screws (gold, tapping, 8mm x2, silver, 6mm, x1) securing the
DRIVE ASSY OTP FDR to the FRAME CVR L550.
5. Remove the DRIVE ASSY OTP FDR.
Installation
1. Install the DRIVE ASSY OTP FDR to the FRAME CVR L550 with the three
screws (gold, tapping, 8mm x2, silver, 6mm, x1).
As the Screw (A) shown in the figure, tighten the screw of
C A U T I O N
silver, 6mm. When securing the screws, be careful not to pinch
the harness.
When securing the screws, be careful not to pinch the harness.
2. Connect the connector (P/J820) of the MOTOR FEEDER, which is installed on
the DRIVE ASSY OTP FDR, to the HARNESS ASSY FDR MOT.
3. Install the COVER LEFT PLATE. (p.305)
When installing the EARTH PLATE, insert its front end to under
C A U T I O N
the COVER LEFT PLATE.
4. Install the 550 FEEDER OPTION. (p.311)
Disassembly and Assembly
3)
Figure 4- 112. DRIVE ASSY OPT FDR Removal
Option 550 Paper Feeder
Screw(A)
4)
DRIVE ASSY OPT FDR
5)
FRAME CVR L550
Revision C
JG3506AA
307
Confidential