5. Carefully insert a new ink cartridge from the top, and push it firmly but gently until it clicks
into place. Be sure the insertion direction is correct, as shown in the illustration below.
SJIC7(R), SJIC7(B),
or SJIC7(G)
6. Close the ink cartridge cover firmly until it clicks in place. The INK LED will now be off.
7. The printer begins charging the ink supply. This operation lasts approximately 1 minute.
(The POWER LED flashes during this operation.)
Note:
Do not turn off the power or open a printer cover while the POWER LED is flashing. This will waste ink,
because the printer has to restart the ink charging process.
8. When the POWER LED quits flashing and stays on, the printer is ready for printing.
2.4.5 Installing Roll Paper
CAUTION:
Be sure to use the specified roll paper. See Section 1.2, "TM-J9000/J9100 Specifications,"
on page 1-2.
To avoid injuries and/or machine failure, make sure not to touch anything other than the
roll paper when the roll paper cover is open.
Note:
Do not open the roll paper cover during printing or paper feeding.
Do not use paper rolls that have the paper glued or taped to the core, because they might cause a paper jam.
To prevent paper jams, make sure nothing obstructs paper coming out of the paper exit, and do not pull
the paper being ejected.
1. Turn on the printer power.
2. Press the cover open button to open the roll paper cover.
2-10 Setup
Figure 2-15 Inserting the ink cartridges
SJIC6(K)
Rev. F