Epson EPL-N3000 Service Manual page 385

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the ROLL REGI METAL to the CLUTCH REGI, and secure it with the E ring.
Fit the cut portion of the CLUTCH REGI on the boss of the
C A U T I O N
CHUTE REGI respectively.
2. Install the CLUTCH ASSY PH to the SHAFT SPEED, and secure it with the E ring.
Fit the cut portion of the CLUTCH ASSY PH on the boss of the
C A U T I O N
CHUTE REGI respectively.
Wind the harness of the CLUTCH ASSY PH one turn around
the portion of the CHUTE REGI shown in the figure. (NOTE
1) ( )
p.384
3. Install the 150 FEEDER ASSY (AcuLaser M4000N). (p.382)
4. With the BTR ASSY installed, install the CHUTE TRANSFER.
In the hole on the left side of the CHUTE TRANSFER, a screw need
C A U T I O N
not be tightened.
5. Install the COVER REAR (AcuLaser M4000N). (p.379)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
6. Install the FUSER ASSY. (p.253)
7. Install the COVER REAR 500. (p.270)
The CLUTCH ASSY PH and CLUTCH REGI are different only in
C H E C K
name; there is no difference between the two in installation.
P O I N T
Disassembly and Assembly
(p.255)
AcuLaser M4000N Unique Disassembly Procedures
Revision C
385
Confidential