Pwba Exit Motor - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.10.2 PWBA EXIT MOTOR

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Remove the COVER LEFT. (p.169)
4. Disconnect the harnesses from the connectors (P/J101, P/J102, P/J103) of the
PWBA EXIT MOTOR.
5. Remove the two screws (silver, 6mm) securing the PWBA EXIT MOTOR to the
frame.
6. Remove the PWBA EXIT MOTOR.
Installation
1. Install the PWBA EXIT MOTOR to the frame with the two screws (silver, 6mm).
2. Connect the connectors (P/J101, P/J102, P/J103) of the harnesses to the connectors
of the PWBA EXIT MOTOR.
3. Install the COVER LEFT. (p.169)
4. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
5. Install the COVER REAR 500. (p.270)
Disassembly and Assembly
Figure 4- 93. PWBA EXIT MOTOR Removal
Electrical
Revision C
PWBA EXIT MOTOR
5)
6)
P/J102
P/J101
P/J103
JG3021EA
286
Confidential