Clutch Assy Ph - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.11.14 CLUTCH ASSY PH

Removal
1. Remove the 550 FEEDER OPTION. (p.311)
2. Remove the six screws (gold, tapping, 8mm) securing the PLATE TIE.
3. Remove the PLATE TIE from the CHUTE OUT.
4. Disconnect the connector (P/J853) of the CLUTCH ASSY PH from the
HARNESS ASSY CLSNR1.
5. Remove the E-ring retaining the CLUTCH ASSY PH and remove the CLUTCH
ASSY PH from the SHAFT FEED.
Installation
1. Install the CLUTCH ASSY PH to the SHAFT FEED, and secure it with the E ring.
When installing it, match the notch of the CLUTCH ASSY PH
C A U T I O N
to the boss of the CHUTE OUT.
Carefully route the harness of the CLUTCH ASSY PH.
2. Connect the connector (P/J853) of the CLUTCH ASSY PH to the HARNESS
ASSY CLSNR1.
Place the connected connector between the ribs of the CHUTE
C A U T I O N
OUT.
3. Install the PLATE TIE to the CHUTE OUT with the six screws (gold, tapping,
8mm).
4. Install the 550 FEEDER OPTION. (p.311)
Disassembly and Assembly
3)
WHEN ASSEMBLING
CHUTE OUT
CONNECTOR
Figure 4- 122. CLUTCH ASSY PH Removal
Option 550 Paper Feeder
CHUTE OUT
4)
2)
PLATE TIE
Revision C
Note 1)
5)
CLUTCH ASSY PH
JG3515AA
318
Confidential