Epson EPL-N3000 Service Manual page 334

EPSON EPL-N3000/AcuLaser M4000N
Installation
Carry out installation with the PLATE ASSY BTM in the raised
C H E C K
position. An inclined PLATE ASSY BTM can cause a paper skew
P O I N T
or paper jam. After installation, make sure that the PLATE ASSY
BTM is not inclined.
1. Fit the SPRING STOPPER GEAR to the STOPPER GEAR, and install the
STOPPER GEAR to the HOUSING BASE 550 with the two screws (gold,
tapping, 6 mm).
When installing the STOPPER GEAR, taking care not to
C A U T I O N
mislay the SPRING STOPPER GEAR.
When installing the STOPPER GEAR, assemble so that the
end of the SPRING STOPPER GEAR makes contact with the
plate on the rear side of the HOUSING BASE 150 as shown in
the figure. (See NOTE 2)
2. Install the GEAR LEVER LOCK to the HOUSING BASE 550.
3. Install the GEAR BTM LOCK to the HOUSING BASE 550.
Disassembly and Assembly
Figure 4- 136. GEAR LEVER LOCK, LEVER BTM LOCK Installation
Option 550 Paper Feeder
NOTE2 (REAR VIEW)
WHEN ASSEMBLING
STOPPER GEAR
SPRING STOPPER GEAR
Revision C
334
Confidential