EPSON EPL-N3000/AcuLaser M4000N
Installation
1.
Install the MOTOR COVER to the frame with the one screw (silver, 6mm).
2.
Connect the harness of the MAIN MOTOR to the clamp.
3.
Install the SHIELD PLATE ROS. (p.243)
4.
Install the ROS ASSY. (p.239)
Never give impact to the ROS ASSY with a screwdriver or the like.
C A U T I O N
5.
Install the DUCT FRONT, FAN SUB. (p.241)
6.
Install the GUIDE TRAY LEFT. (p.236)
7.
Install the COVER FRONT. (p.172)
8.
Install the COVER TOP, CONTROL PANEL. (p.170)
9.
Install the 500 EXIT ASSY. (p.262)
10. Install the COVER EXIT 500. (p.261)
11. Install the COVER RIGHT. (p.168)
12. Install the COVER LEFT. (p.169)
13. Install the FUSER ASSY. (p.253)
14. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
15. Install the COVER REAR 500. (p.270)
16. Install the BTR ASSY. (p.254)
Disassembly and Assembly
Frame & Drive
Revision C
278
Confidential