Cover Top, Control Panel - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.2.4 COVER TOP, CONTROL PANEL

Disassembly procedures for these parts are different between EPL-
C H E C K
N3000 and AcuLaser M4000N. For AcuLaser M4000N, see
P O I N T
COVER TOP, CONTROL PANEL (AcuLaser M4000N)
Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Remove the COVER LEFT. (p.169)
4. Remove the COVER RIGHT. (p.168)
5. Remove the COVER EXIT 500. (p.261)
6. Remove the 500 EXIT ASSY. (p.262)
7. Remove the two screws (silver, with a collar, 8 mm) securing the COVER TOP.
8. Disengage the LEVER LINK from the boss on the COVER OPEN.
Open the COVER OPEN and stretch the LEVER LINK first,
C A U T I O N
and then disengage the LEVER LINK from the COVER
OPEN.
The OPERATION PANEL mounted on the COVER TOP is
connected to the printer body with the connector. When doing
the following work, do not separate them too far.
9. Release the two hooks at the front of the COVER TOP from the COVER FRONT,
and remove and slightly separate the COVER TOP from the printer body.
10. Disconnect the connectors (P/J144, P/J411) of the SWITCH I/L ASSY from the
connectors of the frame.
11. Disconnect the connector (P/J1) of the CONTROL PANEL.
12. Release the harnesses of the SWITCH I/L ASSY and CONTROL PANEL from
the clamps.
13. Remove the COVER TOP.
14. Release the two hooks securing the CONTROL PANEL to the COVER TOP, and
remove the CONTROL PANEL.
Disassembly and Assembly
4.14.2
(p.380).
CONTROL PANEL
Figure 4- 7. COVER TOP, CONTROL PANEL Removal
Cover
8)
9)
14)-1
14-2)
11)
Revision C
COVER OPEN
7)
10)
13)
JG3006EA
170
Confidential