Epson EPL-N3000 Service Manual page 197

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the GEAR SECTOR to the HOUSING EXTENSION 550.
2. Secure the GEAR SECTOR with the one screw (black, with a collar, 8mm).
3. Install the RACK SIZE. (p.192)
4. Install the COVER EXTENSION to the HOUSING EXTENSION 550 with the
four screws (gold, tapping, 6mm).
When installing it, make sure that the COVER EXTENSION is
C H E C K
located under the three claws of the HOUSING EXTENSION
P O I N T
550.
Always use the securing screws of 6mm length. If they are of
8mm length, the HOUSING EXTENSION 550 will not operate
smoothly and the LOCK EXTENSION 550 will not operate
properly.
5. With the LINK SW SIZE 1-550, LINK SW SIZE 2-550 and LINK SW SIZE 3-550 of the
HOUSING BASE 550 pushed to the outside as shown in the figure, assemble the
HOUSING EXTENSION 550 into the HOUSING TOP 550 and HOUSING BASE 550.
Insert the two claws at the front end of the PLATE ASSY BTM into
C H E C K
the hooks of the HOUSING TOP 550.
P O I N T
6. After securing the HOUSING TOP 550 to the HOUSING BASE 550 with the four
hooks, secure it with the two screws (gold, tapping, 8mm) in each of the left and
right sides and the six screws (gold, tapping, 8mm) in the rear side.
After completion of installation, move the GUIDE ASSY END 550
C H E C K
to confirm that the LINK SW SIZE operates smoothly.
P O I N T
7. Insert the link lever of the GUIDE INDICATOR 1 into the hole of the PLATE
ASSY BTM. (p.200)
8. Hold down the hook of the HOUSING TOP 550, and install the GUIDE ASSY SD
R550 to the HOUSING TOP 550.
Disassembly and Assembly
After completion of installation, make sure that the three claws of
C H E C K
the GUIDE ASSY SD R550 are inserted in the grooves of the
P O I N T
HOUSING TOP550.
9. Hold down the hook of the HOUSING TOP 550, and install the GUIDE ASSY SD
L550 to the HOUSING TOP 550.
After completion of installation, make sure that the three claws of
C H E C K
the GUIDE ASSY SD L550 are inserted in the grooves of the
P O I N T
HOUSING TOP550.
10. Push down the PLATE ASSY BTM to have it locked.
11. With the GUIDE ASSY SD L550 and GUIDE ASSY SD R550 spread to the full
on both side, install the GEAR PINION to the HOUSING TOP 550.
Install the GEAR PINION with the GUIDE ASSY SD R550 and
C A U T I O N
L550 opened to their outmost positions. Dislocation of the GUIDE
ASSY SD R550 and/or L550 can dislocate the Side Regi.
12. Install the COVER CST to the cassette body.
After completion of assembling, move the PLATE ASSY BTM up/
C H E C K
down, and make certain that the LOW IND FRONT moves up/
P O I N T
down synchronously.
550 Paper Cassette
Revision C
197
Confidential