Aculaser M4000N Unique Disassembly Procedures; Cover Rear (Aculaser M4000N) - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N
4.14 AcuLaser M4000N Unique Disassembly
Procedures

4.14.1 COVER REAR (AcuLaser M4000N)

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the five screws (silver, with a collar, 8 mm x2; silver, tapping, 8 mm x3)
securing the COVER REAR.
3. Open the COVER REAR as shown with the arrow and release the three hooks.
4. Disconnect the relay connector from the MAIN FAN 80 and remove the COVER
REAR.
Installation
1. Connect the relay connector to the MAIN FAN 80.
2. Insert the three hooks on the left side of the COVER REAR into the holes of the
printer body, and install the COVER REAR to the printer body.
3. Secure the COVER REAR with the three screws (silver, with a collar, 8 mm x2;
silver, tapping, 8 mm x3).
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
When securing the screws, be careful not to pinch the harness.
4. Install the COVER REAR 500. (p.270)
Disassembly and Assembly

AcuLaser M4000N Unique Disassembly Procedures

4)
3)
2)
Figure 4-174. COVER REAR Removal
Revision C
J23143EA
379
Confidential