Clutch Assy Ph - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.6.5 CLUTCH ASSY PH

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the FUSER ASSY. (p.253)
3. Remove the COVER REAR. (p.167)
4. Remove the FAN MAIN. (p.293)
5. With the BTR ASSY installed, remove the CHUTE TRANSFER.
6. Remove the 150 FEEDER ASSY. (p.211)
7. Remove the 550 FEEDER ASSY. (p.224)
8. Remove the six screws (gold, tapping, 8mm) securing the PLATE TIE to the
CHUTE OUT, and remove the PLATE TIE.
9. Disconnect the connector (P/J247) of the CLUTCH ASSY PH from the
HARNESS ASSY TRAY 2.
10. Remove the E-ring retaining the CLUTCH ASSY PH and remove the CLUTCH
ASSY PH from the SHAFT FEED.
Disassembly and Assembly
(p.255)
550 Paper Feeder
CHUTE OUT
9)
8)
PLATE TIE
Note1
CHUTE OUT
CONNECTOR
Figure 4- 53. CLUTCH ASSY PH Removal
Revision C
10)
CLUTCH ASSY PH
JG3052AA
230
Confidential