Epson EPL-N3000 Service Manual page 220

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the ROLL REGI METAL to the CLUTCH REGI, and secure it with the E ring.
Fit the cut portion of the CLUTCH REGI on the boss of the
C A U T I O N
CHUTE REGI respectively.
2. Connect the connector (P/J243) of the CLUTCH REGI to the HARNESS ASSY
TRAY 1.
3. Install the CLUTCH ASSY PH to the SHAFT SPEED, and secure it with the E ring.
Fit the cut portion of the CLUTCH ASSY PH on the boss of the
C A U T I O N
CHUTE REGI respectively.
Wind the harness of the CLUTCH ASSY PH one turn around
the portion of the CHUTE REGI shown in the figure. (NOTE
1) ( )
p.219
4. Connect the connector (P/J242) of the CLUTCH ASSY PH to the HARNESS
ASSY TRAY 1.
5. Install the 150 FEEDER ASSY. (p.211)
6. With the BTR ASSY installed, install the CHUTE TRANSFER.
In the hole on the left side of the CHUTE TRANSFER, a screw need
C A U T I O N
not be tightened.
7. Install the FAN MAIN. (p.293)
8. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
9. Install the FUSER ASSY. (p.253)
Disassembly and Assembly
10. Install the COVER REAR 500. (p.270)
C H E C K
P O I N T
(p.255)
150 Paper Feeder
The CLUTCH ASSY PH and CLUTCH REGI are different only in
name; there is no difference between the two in installation.
Revision C
220
Confidential