Epson EPL-N3000 Service Manual page 218

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Move the ROLL REGI RUBBER in the direction opposite to the arrow, and install
it to the 150 FEEDER ASSY.
When installing the ROLL REGI RUBBER, take care not to hold
C A U T I O N
any rubber portion.
Install the ROLL REGI RUBBER, with the D cut portion at the
C H E C K
front end of the shaft located on the BEARING REGI RIGHT side.
P O I N T
2. Fit the BEARING REGI RIGHT to the ROLL REGI RUBBER.
Pay attention to the flange shape and hook position of the
C A U T I O N
BEARING REGI RIGHT (White) and BEARING REGI LEFT
(Black).
3. Turn the BEARING REGI RIGHT in the direction opposite to that in the figure,
and install the BEARING REGI RIGHT to the CHUTE REGI.
4. Fit the BEARING REGI LEFT to the ROLL REGI RUBBER.
Pay attention to the flange shape and hook position of the
C A U T I O N
BEARING REGI RIGHT (White) and BEARING REGI LEFT
(Black).
5. Turn the BEARING REGI LEFT in the direction opposite to that in the figure, and
install the BEARING REGI LEFT to the CHUTE REGI.
6. Fit the E ring to the ROLL REGI RUBBER to secure the BEARING REGI LEFT.
7. Install the GEAR REGI RUBBER to the ROLL REGI RUBBER, and secure it
with the E ring.
8. Hitch the two SPRINGs REGI on the CHUTE REGI and BEARING REGI
RUBBER.
Disassembly and Assembly
For installation of the SPRINGs REGI, set their one end on the
C A U T I O N
bosses of the CHUTE REGI and hook the other end to the inside of
the hook on each of the BEARING REGI LEFT and BEARING
REGI RIGHT.
After installation, make sure that the HARNESS ASSY TONER 2
is not caught by the SPRING REGI. (NOTE2) (
9. Install the CLUTCH ASSY PH, CLUTCH REGI. (p.219)
10. Install the 150 FEEDER ASSY. (p.211)
11. Install the CHUTE TRANSFR. (p.255)
In the hole on the left side of the CHUTE TRANSFER, a screw need
C A U T I O N
not be tightened.
12. Install the FAN MAIN. (p.293)
13. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
14. Install the FUSER ASSY. (p.253)
15. Install the COVER REAR 500. (p.270)
150 Paper Feeder
Revision C
)
p.217
218
Confidential