Lever Latch Right - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N
4.8.12 LEVER LATCH LEFT, SPRING LATCH FU,

LEVER LATCH RIGHT

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the five screws (gold, tapping, 6mm) securing the CHUTE LOW FU to
the COVER REAR 500.
3. Release the hook of the COVER REAR 500, and remove the CHUTE LOW FU
from the COVER REAR 500.
4. Remove the ROLL FU. (p.271)
5. Remove the LEVER GATE HOLDER, SPRING LEVER GATE, LEVER GATE FU.
(p.272)
6. Rotate the LEVER LATCH LEFT in the direction of the arrow, and remove it.
Securely match the projection located inside the LEVER LATCH
C H E C K
LEFT and the notch of the CHUTE LOW FU.
P O I N T
7. Rotate the LEVER LATCH RIGHT in the direction of the arrow and remove it.
Securely match the projection located inside the LEVER
C H E C K
LATCH RIGHT and the notch of the CHUTE LOW FU.
P O I N T
The PIPE LATCH FU will detach simultaneously with the
LEVER LATCH RIGHT.
8. Remove the SPRING LATCH FU.
Installation
1. Install the SPRING LATCH FU.
2. Install the LEVER LATCH LEFT to the PIPE LATCH FU and the CHUTE LOW
FU.
3. Install the LEVER LATCH RIGHT to the PIPE LATCH FU.
Disassembly and Assembly
4. Match the projections of both the LEVER LATCH RIGHT and LEVER LATCH
LEFT to the notches of the CHUTE LOW FU, and rotate it in the opposite
direction of the arrow, and then install it.
5. Install the LEVER GATE HOLDER, SPRING LEVER GATE, LEVER GATE FU.
(p.272)
6. Install the ROLL FU. (p.271)
7. Install the CHUTE LOW FU to the COVER REAR 500, and secure it at the hook.
8. Secure the CHUTE LOW FU to the COVER REAR 500 with the five screws
(gold, tapping, 6mm).
9. Install the COVER REAR 500. (p.270)
LEVER LATCH LEFT
SORING LATCH FU
Figure 4- 84. LEVER LATCH LEFT, SPRING LATCH FU,
LEVER LATCH RIGHT Removal
500 Paper Exit
Revision C
LEVER LATCH RIGHT
JG3304AA
273
Confidential