Cover; Cover Rear - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.2 Cover

4.2.1 COVER REAR

Disassembly procedures for this part are different between EPL-
C H E C K
N3000 and AcuLaser M4000N. For AcuLaser M4000N, see
P O I N T
COVER REAR (AcuLaser M4000N)
Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the three screws (silver, with a collar, 8 mm x2; gold, tapping, 8 mm x1)
securing the COVER REAR.
3. Open the COVER REAR as shown with the arrow and release the three hooks, and
remove the COVER REAR from the printer body.
Installation
1. Insert the three hooks on the left side of the COVER REAR into the holes of the
printer body, and install the COVER REAR to the printer body.
2. Secure the COVER REAR with the three screws (sliver, with collars, 8mm x2,
gold, tapping, 8mm x1).
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
When securing the screws, be careful not to pinch the harness.
3. Install the COVER REAR 500. (p.270)
Disassembly and Assembly
4.14.1
(p.379).
Cover
3)
2)
Figure 4- 4. COVER REAR Removal
Revision C
JG3003EA
167
Confidential