EPSON EPL-N3000/AcuLaser M4000N
Installation
1.
Move the GUIDE TRAY LEFT in the directions opposite to the arrows (A), (B),
and install it to the frame.
2.
Install the GUIDE TRAY LEFT with the six screws (gold, tapping, 8mm x1, gold,
6mm x5).
In the place of the Screw (A) in the figure, tighten the screw (gold,
C A U T I O N
tapping, 8mm).
(Refer to Figure 4- 56)
3.
Connect the HARNESS ASSY LVPS to the connector (P/J1821) of the GUIDE
TRAY LEFT.
4.
Return the printer body to the normal position.
5.
Install the COVER FRONT. (p.172)
6.
Install the COVER TOP, CONTROL PANEL. (p.170)
7.
Install the 500 EXIT ASSY. (p.262)
8.
Install the COVER EXIT 500. (p.261)
9.
Install the COVER RIGHT. (p.168)
10. Install the COVER LEFT. (p.169)
11. Install the FUSER ASSY. (p.253)
12. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
13. Install the COVER REAR 500. (p.270)
14. Install the Imaging Cartridge and Paper Cassette.
Disassembly and Assembly
550 Paper Feeder
Revision C
237
Confidential