Checking The Status Of The Fabric; Installing The Fabric Roll; U "Checking The Status Of The Fabric; U "Installing The Fabric Roll - Epson ML-13000 User Manual

ML-13000 User's Manual
Setting the Fabric Floating Sensor
Printing will stop if the Fabric Floating Sensor detects that the fabric is floating or curling beyond the height set here.
"Setting the Fabric Floating Sensor" on page 93
U
Setting fabric information
Register the Fabric Information every time you change the fabric type or fabric thickness.
"Setting Fabric Information" on page 92
U
Printing
Start printing with the print tool.
Before printing, make sure that the heated pressure roller is lowered and the fabric is firmly attached to the belt.
"Printing" on page 95
U
When the fabric is finished or when you want to change to a different fabric while there is still some fabric left, replace or
add a new fabric roll.
"Replacing the Fabric" on page 96
U
"Adding Fabric" on page 109
U

Checking the Status of the Fabric

Before setting the fabric, be sure to confirm the following status.
❏ Fabric end: No creases, wrinkles, or fraying
❏ Seams: No creases or fraying
If there are creases or wrinkles, straighten out the fabric.
If the fabric is frayed, perform overcasting.

Installing the Fabric Roll

Pass the fabric roll through the feeding spindle and install it in the feeding unit.
Use a feeding spindle corresponding to the inner diameter of the roll core of the fabric roll.
Basic Operations
60