Actuator No Paper - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.6.9 ACTUATOR NO PAPER

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the FUSER ASSY. (p.253)
3. Lay the printer body on its left side.
Take care not to damage the covers. In addition, take care not to
C A U T I O N
apply any impact from above.
4. Open the COVER OPEN.
5. While lifting the boss of the HOLDER LEFT on the rear side of the 550 FEEDER
ASSY, shift the HOLDER LEFT in the direction of the arrow, and release the
three hooks.
6. Remove the HOLDER LEFT from the SUPPORT NUDGER. At the same time,
the ACTUATOR NO PAPER comes off.
Installation
1. Install the HOLDER LEFT and ACTUATOR NO PAPER to the SUPPORT
NUDGER.
Securely fit the shafts on both ends of the ACTUATOR NO
C A U T I O N
PAPER into the HOLDER LEFT and SUPPORT NUDGER.
Hitch the hook of the ACTUATOR NO PAPER on the
HOLDER LEFT.
After installation, operate the ACTUATOR NO PAPER with your
C H E C K
finger and make sure that it moves properly.
P O I N T
2. Move the HOLDER LEFT in the direction opposite to the arrow, and secure it to
the 550 FEEDER ASSY with the three hooks.
3. Return the printer body to the normal position.
4. Install the FUSER ASSY. (p.253)
5. Install the COVER REAR 500. (p.270)
Disassembly and Assembly
SUPPORT
NUDGER
ACTUATOR
NO PAPER
LIFT UP
(BOSS)
UNDER VIEW
SUPPORT NUDGER
ACTUATOR NO PAPER
HOLDER
LEFT
LIFT UP
(BOSS)
Figure 4- 57. ACTUATOR NO PAPER Removal
550 Paper Feeder
Revision C
ACTUATOR NO PAPER
HOLDER
HOOK
LEFT
HOLDER
LEFT
HOLDER LEFT
HOOK
JG3198AA
Confidential
238