Table of Contents
Advertisement
RIP
STP
VRRP
If the software has been running less than 15 minutes (the maximum interval for utilization statistics), the
command indicates how long the software has been running. Here is an example:
BigIron# show process cpu
The system has only been up for 6 seconds.
Process Name
5Sec(%)
ARP
BGP
ICMP
IP
OSPF
RIP
STP
VRRP
To display utilization statistics for a specific number of seconds, enter a command such as the following:
BigIron# show process cpu 1
Process Name
Sec(%)
ARP
BGP
ICMP
IP
OSPF
RIP
STP
VRRP
Syntax: show process cpu [<num>]
The <num> parameter specifies the number of seconds and can be from 1 – 900. If you use this parameter, the
command lists the usage statistics only for the specified number of seconds. If you do not use this parameter, the
command lists the usage statistics for the previous one-second, one-minute, five-minute, and fifteen-minute
intervals.
USING THE WEB MANAGEMENT INTERFACE
You cannot display this information using the Web management interface.
Displaying IP Interface Information
To display IP interface information, use one of the following methods.
USING THE CLI
To display IP interface information, enter the following command at any CLI level:
BigIron(config)# show ip interface
Interface
Ethernet 1/1
Ethernet 1/2
Loopback 1
Syntax: show ip interface [ethernet <portnum>] | [loopback <num>] | [ve <num>]
This display shows the following information.
December 2000
0.00
0.00
0.00
0.00
0.00
0.00
1Min(%)
5Min(%)
0.01
0.00
0.00
0.00
0.01
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
Time(ms)
0.00
0
0.00
0
0.01
1
0.00
0
0.00
0
0.00
0
0.00
0
0.00
0
IP-Address
OK?
207.95.6.173
YES
3.3.3.3
YES
1.2.3.4
YES
0.00
0.00
0.00
0.00
0.00
0.00
15Min(%)
Runtime(ms)
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
Method
Status
NVRAM
up
manual
up
NVRAM
down
Configuring IP
0
0
0
0
0
1
0
0
0
0
0
Protocol
up
up
down
15 - 87
- Quick Links:
- Configuring Ip Addresses
Hide quick links:
Advertisement
Chapters
Table of Contents
