Foundry Networks Switch and Router Installation And Configuration Manual page 771

This Field...
Maximum Number of Paths
Supported for Load Sharing
Number of Neighbors Configured
Number of Routes Installed
Number of Routes Advertising to All
Neighbors
Number of Attribute Entries Installed
Neighbor Address
December 2000
Table 19.4: BGP4 Summary Information (Continued)
Displays...
The maximum number of route paths across which the device can
balance traffic to the same destination. The feature is enabled by
default but the default number of paths is 1. You can increase the
number from 2 – 8 paths. See "BGP4 Load Sharing".
The number of BGP4 neighbors configured on this Layer 3 Switch.
The number of BGP4 routes in the router's BGP4 route table.
To display the BGP4 route table, see "Displaying the BGP4 Route
Table" on page 19-107.
The total of the RtSent and RtToSend columns for all neighbors.
The number of BGP4 route-attribute entries in the router's route-
attributes table. To display the route-attribute table, see "Displaying
BGP4 Route-Attribute Entries" on page 19-114.
The IP addresses of this router's BGP4 neighbors.
Configuring BGP4
19 - 89