Foundry Networks Switch and Router Installation And Configuration Manual page 1011

Syntax
Use the following CLI commands or Web management interface panels to configure QoS policies.
QoS Scope
Individual port
VLAN
a
Static MAC address
Layer 4 session
AppleTalk socket
a. You can configure static MAC addresses on Layer 2 Switches but not on Layer 3 Switches.
December 2000
Table C.4: QoS Policies
CLI syntax
BigIron(config-if-1/1)# priority <0-7>
TurboIron(config-if-1)# priority normal | high
BigIron(config-vlan-8)# priority <0-7>
TurboIron(config-vlan-8)# priority normal | high
BigIron(config)# static-mac-address
<mac-addr> ethernet <portnum>
[priority <0-7>] [host-type | router-type]
TurboIron(config)# static-mac-address
<mac-addr> ethernet <portnum>
[normal-priority | high-priority]
[host-type | router-type]
BigIron(config)# ip access-policy <num>
priority <0-7> <ip-addr> <ip-mask> | any
<ip-addr> <ip-mask> | any tcp | udp
[<operator> [<tcp/udp-port-num>]]
BigIron(config-if-1/1)# ip access-policy-group in |
out <policy-list>
FastIronII(config) ip policy <num> priority <0-7>
tcp | udp <tcp/udp-port-num> global | local
FastIronII(config-if-1/1) ip-policy <num>
TurboIron(config)# ip access-policy <num>
high | normal <ip-addr> <ip-mask> | any
<ip-addr> <ip-mask> | any tcp | udp
[<operator> [<tcp/udp-port-num>]]
TurboIron(config-if-1)# ip access-policy-group in |
out <policy-list>
ServerIron(config)# ip policy <index> cache | fw |
normal | high tcp | udp
<tcp/udp-port-num> global | local
ServerIron(config-if-1)# ip-policy <num>
Note: You need this command only if you define
local policies on the ServerIron.
BigIron(config)# appletalk qos socket <number>
priority <0-7>
Policies and Filters
Web management links
Configure->Port
Configure->VLAN->Port
Configure->Static Station
Configure->IP->Access Policy
Layer 4 QoS (link from the
System configuration panel)
System->Layer 4 QoS
Configure->IP->AppleTalk
->Socket QoS
C - 7