Displaying And Modifying System Parameter Default Settings - Foundry Networks Switch and Router Installation And Configuration Manual

Foundry Switch and Router Installation and Configuration Guide
NOTE: Router acceleration is supported only on the FastIron Backbone and TurboIron Backbone Layer 2
Switches.
You must reset the switch for the changes to become effective.
USING THE CLI
To enable IP router acceleration on a Foundry backbone Layer 2 Switch (Stackable):
FastIron(config)# ip-route-accelerating
FastIron(config)# end
FastIron# write memory
FastIron# reload
Syntax: ip-route-accelerating
To enable IPX router acceleration on a Foundry backbone Layer 2 Switch (Stackable):
FastIron(config)# ipx-route-accelerating
FastIron(config)# end
FastIron# write memory
FastIron# reload
Syntax: ipx-route-accelerating
USING THE WEB MANAGEMENT INTERFACE
You cannot enable or disable router acceleration using the Web management interface.

Displaying and Modifying System Parameter Default Settings

Foundry devices have default table sizes for the following parameters. The table sizes determine the maximum
number of entries the tables can hold. You can adjust individual table sizes to accommodate your configuration
needs.
• MAC address entries
• Layer 2 Port VLANs supported on a system
• Layer 3 Protocol VLANs supported on a system
• Layer 4 sessions supported
• IP cache size
• ARP entries
• IP routes
• IP route filters
• IP sub-nets per port and per device
• Static routes
• IGMP
• DVMRP routes
• IPX/SAP entries
• IPX/RIP entries
• IPX/SAP filters
• IPX/RIP filters
10 - 70 December 2000