Displaying Vlan Information For Specific Ports - Foundry Networks Switch and Router Installation And Configuration Manual

Foundry Switch and Router Installation and Configuration Guide
Static ports: None
Exclude ports: None
Dynamic ports: (S2)
Syntax: show vlans [<vlan-id> | ethernet <portnum>]
USING THE WEB MANAGEMENT INTERFACE
To display VLAN configuration information:
1. Log on to the device using a valid user name and password for read-only or read-write access. The System
configuration dialog is displayed.
2. Click on the plus sign next to Configure in the tree view to expand the list of configuration options.
3. Click on the plus sign next to VLAN in the tree view to expand the list of VLAN option links.
4. Click on the Port link to display the Port-based VLAN table or the Protocol link to display the Protocol-based
VLAN table.

Displaying VLAN Information for Specific Ports

Use one of the following methods to display VLAN information for specific ports.
USING THE CLI
To display VLAN information for all the VLANs of which port 7/1 is a member, enter the following command:
BigIron(config)# show vlans e 7/1
Total PORT-VLAN entries: 3
Maximum PORT-VLAN entries: 8
legend: [S=Slot]
PORT-VLAN 100, Name [None], Priority level0, Spanning tree Off
Untagged Ports: (S7)
Tagged Ports: None
IP-subnet VLAN 207.95.11.0 255.255.255.0, Dynamic port disabled
Static ports: (S7)
Exclude ports: None
Dynamic ports: None
Syntax: show vlans [<vlan-id> | ethernet <portnum>]
The <vlan-id> parameter specifies a VLAN for which you want to display the configuration information.
The ethernet <portnum> parameter specifies a port.
USING THE WEB MANAGEMENT INTERFACE
You cannot display port-specific VLAN information using the Web management interface.
25 - 64
1 2 3 4 5 6
1 2 3 4
1 2
December 2000