Foundry Networks Switch and Router Installation And Configuration Manual page 276

Foundry Switch and Router Installation and Configuration Guide
BigIron> show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 3 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
Static Log Buffer:
Dec 15 19:04:14:A:Fan 1, fan on right connector, failed
Dynamic Log Buffer (50 entries):
Dec 15 18:46:17:I:Interface ethernet4, state up
Dec 15 18:45:21:I:Bridge topology change, vlan 4095, interface 4, changed
state to forwarding
Dec 15 18:45:15:I:Warm start
Syntax: show logging
The Syslog display shows the following configuration information, in the rows above the log entries themselves.
This Field...
Syslog logging
messages dropped
flushes
overruns
level
messages logged
level code
Static and Dynamic Buffers
The software provides two separate buffers:
• Static – logs power supply failures, fan failures, and temperature warning or shutdown messages
10 - 18
I=informational N=notification W=warning
Table 10.3: CLI Display of Syslog Buffer Configuration
Displays...
The state (enabled or disabled) of the Syslog buffer.
The number of Syslog messages dropped due to user-configured
filters. By default, the software logs messages for all Syslog levels.
You can disable individual Syslog levels, in which case the software
filters out messages at those levels. See "Disabling Logging of a
Message Level" on page 10-16. Each time the software filters out a
Syslog message, this counter is incremented.
The number of times the Syslog buffer has been cleared by the clear
logging command or equivalent Web management interface option.
See "Clearing the Syslog Messages from the Local Buffer" on
page 10-21.
The number of times the dynamic log buffer has filled up and been
cleared to hold new entries. For example, if the buffer is set for 100
entries, the 101st entry causes an overrun. After that, the 201st entry
causes a second overrun.
The message levels that are enabled. Each letter represents a
message type and is identified by the key (level code) below the
value. If you disable logging of a message level, the code for that
level is not listed.
The total number of messages that have been logged since the
software was loaded.
The message levels represented by the one-letter codes.
December 2000