Vrrp Example - Foundry Networks Switch and Router Installation And Configuration Manual

STP
VRRP
If the software has been running less than 15 minutes (the maximum interval for utilization statistics), the
command indicates how long the software has been running. Here is an example:
BigIron# show process cpu
The system has only been up for 6 seconds.
Process Name 5Sec(%)
ARP
BGP
ICMP
IP
OSPF
RIP
STP
VRRP
To display utilization statistics for a specific number of seconds, enter a command such as the following:
BigIron# show process cpu 1
Process Name Sec(%)
ARP
BGP
ICMP
IP
OSPF
RIP
STP
VRRP
Syntax: show process cpu [<num>]
The <num> parameter specifies the number of seconds and can be from 1 – 900. If you use this parameter, the
command lists the usage statistics only for the specified number of seconds. If you do not use this parameter, the
command lists the usage statistics for the previous one-second, one-minute, five-minute, and fifteen-minute
intervals.
USING THE WEB MANAGEMENT INTERFACE
You cannot display this information using the Web management interface.
Configuration Examples
The following sections contain the CLI commands and Web management options for implementing the VRRP and
VRRPE configurations shown in Figure 21.2 on page 21-3 and Figure 21.3 on page 21-7.
NOTE: The Web management example applies only to VRRP. You cannot configure VRRPE using the Web
management interface.

VRRP Example

To implement the VRRP configuration shown in Figure 21.2 on page 21-3, use either of the following methods.
USING THE CLI
Configuring Router1 Using the CLI
To configure VRRP Router1, enter the following commands:
Router1(config)# router vrrp
Router1(config)# inter e 1/6
Router1(config-if-1/6)# ip address 192.53.5.1
December 2000
0.00 0.00
0.03 0.07
1Min(%) 5Min(%)
0.01 0.00
0.00 0.00
0.01 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
Time(ms)
0.00 0
0.00 0
0.01 1
0.00 0
0.00 0
0.00 0
0.00 0
0.00 0
0.00 0.00
0.09 0.10
15Min(%) Runtime(ms)
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
Configuring VRRP and VRRPE
0
8
0
0
1
0
0
0
0
0
21 - 31