Foundry Networks Switch and Router Installation And Configuration Manual page 601

Figure 17.7 Redistributing OSPF and static routes to RIP routes
USING THE CLI
EXAMPLE:
To configure the BigIron Layer 3 Switch acting as an ASBR in Figure 17.7 to redistribute OSPF, BGP4, and static
routes into RIP, enter the following commands:
BigIronASBR(config)# router rip
BigIronASBR(config-rip-router)# permit redistribute 1 all
BigIronASBR(config-rip-router)# write memory
NOTE: Redistribution is permitted for all routes by default, so the permit redistribute 1 all command in the
example above is shown for clarity but is not required.
You also have the option of specifying import of just OSPF, BGP4, or static routes, as well as specifying that only
routes for a specific network or with a specific cost (metric) be imported, as shown in the command syntax below:
December 2000
RIP Domain
BigIron
BigIron
ASBR (Autonomous System Border Router)
OSPF Domain
BigIron
Configuring OSPF
17 - 27